Loading... Please wait...

Arduino Wireless Transmitter Receiver Module 433 MHz

Hover over image to zoom

  • Arduino Wireless Transmitter Receiver Module 433 MHz
$0.99
SKU:
WIRELESS433
Condition:
New
Weight:
1.00 Grams
Availability:
Ships within 24 hours from Cleveland, Ohio.
Shipping:
Calculated at checkout

Sorry but this item is currently unavailable. Please check back at a later stage.

 Product Description

The Arduino Wireless Transmitter Receiver Module 433 MHz is the perfect module for wireless communication projects.

Transmitter :

  • Working voltage: 3V - 5V - 12V For maximum transmitting power use up to 12V
  • Working current: max Less than 40mA max , and min 9mA
  • Resonance mode: (SAW)
  • Modulation mode: ASK: Amplitude-Shift Keying (See description below)
  • Working frequency: Eve 315MHz Or 433MHz
  • Transmission power: 25mW (315MHz at 12V)
  • Frequency error: +150kHz (max)
  • Velocity : less than 10Kbps

This module will transmit up to 90m in open area.

 

Receiver :

  • Working voltage: 5.0VDC +0.5V
  • Working current:≤5.5mA max
  • Working method: OOK/ASK: On-Off Keying - denotes the simplest form of amplitude-shift keying (ASK) modulation that represents digital data as the presence or absence of a carrier wave. Amplitude-Shift Keying - is a form of amplitude modulation that represents digital data as variations in the amplitude of a carrier wave. In an ASK system, the binary symbol 1 is represented by transmitting a fixed-amplitude carrier wave and fixed frequency for a bit duration of T seconds. If the signal value is 1 then the carrier signal will be transmitted; otherwise, a signal value of 0 will be transmitted.
  • Working frequency: 315MHz-433.92MHz
  • Bandwidth: 2MHz
  • Sensitivity: excel –100dBm (50Ω)
  • Transmitting velocity: <9.6Kbps (at 315MHz and -95dBm)

433mhz Antenna Boost Notes :

The first rule about good reception is to have a good antenna. The use of an optional antenna will increase the effectiveness of your wireless communication. When using an external antenna a 1/4 wavelength is recommended. Ideally use 50 impedance ohm single-core wire, the length of the antenna 433M is about 17cm (1/4 wavelength). When locating the receiver antenna keep it as far away as possible from shielded areas, high voltages, and any other possible interfering frequencies.

 

 Find Similar Products by Category

Vendors Other Products

You Recently Viewed...

newsletter

Copyright 2018 Resistor Park. All Rights Reserved.
Sitemap | BigCommerce Design by PSDCenter

Click the button below to add the Arduino Wireless Transmitter Receiver Module 433 MHz to your wish list.